Effect of Sintering Temperature on Electrical and Microstructure Properties of Hot Pressed Cu-TiC Composites

Authors

  • S. Islak Kastamonu University, Faculty of Engineering and Architecture, Department of Materials Science and Nanotechnology Engineering
  • D. Kır Kocaeli University, Hereke Vocational High School
  • S. Buytoz Firat University, Faculty of Technology, Department of Metallurgy and Materials Engineering

Abstract

In this study, Cu-TiC composites were successfully produced using hot pressing method. Cu-TiC powder mixtures were hot-pressed for 4 min at 600, 700 and 800 °C under an applied pressure of 50 MPa. Phase composition and microstructure of the composites hot pressed at different temperatures were characterized by X-ray diffraction, scanning electron microscope, and optic microscope techniques. Microstructure studies revealed that TiC particles were distributed uniformly in the Cu matrix. With the increasing sintering temperature, hardness of composites changed between 64.5 HV0.1 and 85.2 HV0.1. The highest electrical conductivity for Cu-10 wt.% TiC composites was obtained for the sintering temperature of 800 °C, with approximately 68.1 % IACS.

Downloads

Published

2017-12-13

Issue

Vol. 46 No. 1 (2014)

Section

Articles