Influence of Powder Characteristics on Hot-pressed Si3N4 Ceramics

Authors

  • Qiang-Guo Jiang School of Electro-mechanical Engineering, Guangdong University of Technology
  • Wei-Ming Guo School of Electro-mechanical Engineering, Guangdong University of Technology
  • Wei Liu School of Electro-mechanical Engineering, Guangdong University of Technology
  • Shang-Xian Gu School of Electro-mechanical Engineering, Guangdong University of Technology
  • Li-Xia Cheng School of Electro-mechanical Engineering, Guangdong University of Technology
  • Jia Liu School of Electro-mechanical Engineering, Guangdong University of Technology
  • Mao-Peng Zhou School of Electro-mechanical Engineering, Guangdong University of Technology
  • Shang-Hua Wu School of Electro-mechanical Engineering, Guangdong University of Technology

Abstract

In this paper, the influence of the starting powder characteristics for five commercial Si3N4 powders on sintering behavior, microstructure and mechanical properties of hot-pressed Si3N4 ceramics with and without the addition of La2O3-Yb2O3-MgO sintering additives was investigated. For the system without sintering additives, the high amount of the impurities in the starting powders could facilitate the densification process and promote β-Si3N4 grain growth. However, large whisker-like particles (α phase) present in the initial powders inhibited the sintering process, which led to a lower density of Si3N4 ceramics. On the other hand, when the sintering additives were introduced in the beginning stage of the powder processing step, the effects of impurities content and particle morphology in the initial powders on the densification and microstructure were not apparent. There was tendency that finer powder size resulted in finer microstructure. However, a high α-phase ratio in the initial powders could accelerate the abnormal grain growth and thus lead to better mechanical properties.

Downloads

Published

2017-12-13

Issue

Vol. 49 No. 1 (2017)

Section

Articles