The Effect of Aging Processes on Tribo-Metallurgy Properties of Al Based Ternary Alloys Product by P/M Technique

Authors

  • Yavuz Kaplan Pamukkale University Faculty of Technology, Department of Mechanical and Manufacturing Engineering
  • Sinan Aksöz Pamukkale University Faculty of Technology, Department of Metallurgy and Materials Engineering
  • Hakan Ada Kastamonu University Faculty of Engineering and Architecture, Department of Mechanical Engineering
  • Emre İnce Kastamonu University Institute of Science and Technology
  • Serkan Özsoy Kastamonu University Institute of Science and Technology

Abstract

In this study, Al matrix composites consisting of different amounts of Zn, Cu, and Mg were produced using the powder metallurgy technique. In the alloying, powders were ball milled for 120 min via mechanical alloying. After alloying process, the powders were pressed at 800 MPa at room temperature. Sintering (2 h at 600 °C in argon atmosphere), solution treatment (2 h at 480 °C), and aging processes (3, 6, 9, and 12 h, respectively, at 120 °C) were applied to the samples. The hardness and tribo-metallurgy properties of the products were investigated. After sintering, the hardness values of the three alloys were close to each other; however, the solution treatment after sintering caused the hardness values to increase significantly. It was determined that the Al-2Zn-5Cu-4Mg alloy had the highest hardness increase with the 6-h aging heat treatment. The wear resistance of the materials in all the compositions had increased. The highest wear resistance and lowest friction coefficient were obtained for the Al-2Zn-5Cu-4Mg alloy with the 6-h aging heat treatment.

Downloads

Published

2020-11-15

Issue

Vol. 52 No. 4 (2020)

Section

Articles

License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Authors retain copyright of the published papers and grant to the publisher the right to publish the article, to be cited as its original publisher in case of reuse, and to distribute it in all forms and media. Articles will be distributed under the Creative Commons Attribution International License (CC BY 4.0).