Investigation of Bi2Te2.88Se0.12 Bulk Single Crystal Produced Using Bridgman Method

Authors

  • Emina Požega Mining and Metallurgy Institute Bor, 19210 Bor, Serbia
  • Slavko Bernik Jožef Stefan Insititute, 1000 Ljubljana, Slovenia
  • Saša Marjanović University of Belgrade, Technical Faculty Bor, VJ 12, 19210 Bor, Serbi
  • Ana Petrović Mining and Metallurgy Institute Bor, 19210 Bor, Serbia
  • Igor Svrkota Mining and Metallurgy Institute Bor, 19210 Bor, Serbia
  • Anđela Stojić University of Belgrade, Technical Faculty Bor, VJ 12, 19210 Bor, Serbia
  • Danijela Simonović Mining and Metallurgy Institute Bor, 19210 Bor, Serbia

Abstract

As part of research on the influence of selenium as dopant on bismuth telluride, a successful synthesis of single crystal was carried out. Single crystal of p type conductivity, with the given compound formula, Bi2Te2.88Se0.12, was obtained by the Bridgman process. The obtained empirical formula does not deviate from the given compound formula. Single crystal was characterized by Hall Effect system based on the Van der Pauw method. Also, bulk sample was characterized by Seebeck coefficient (S), thermal conductivity (κ) and electrical resistivity (ρ) measurements, as а function of temperature in the range of 40-320°C by а homemade impedance meter. The prepared single crystal has a figure of merit (Z) of 2.16 x 10-3 K-1 at 40°C. Values of ZT are about 1.0 at 27°C for commercialized p and n type of bismuth telluride ingots. T is absolute temperature.

Downloads

Published

2024-08-12

Issue

Vol. 56 No. 3 (2024)

Section

Articles

License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Authors retain copyright of the published papers and grant to the publisher the right to publish the article, to be cited as its original publisher in case of reuse, and to distribute it in all forms and media. Articles will be distributed under the Creative Commons Attribution International License (CC BY 4.0).